Urethane Drain Protector

A tacky, adhesive surface creates a positive seal that stops chemical spills every time. A positive seal prevents even the smallest amount of contaminant/liquid from getting past. Positive seals do not allow any external or internal leakage, whereas non-positive seals allow a small amount of internal leakage. When dealing with hazardous materials or toxic chemicals, a positive seal is a must-have.

The polyurethane DrainProtector™ is compatible for use with a wider range of chemicals and substances than rubbers and plastics. It’s often more suitable when coming into contact with certain solvents, oils, and chemicals. Plus, it’s environmentally safe!

The DrainProtector™ safety seal has a chemical compatibility rating of “Good” with the following chemicals:

• Acetone
• Chlorine Standard Solution (1000ppm)
• Ethanol (95%)
• Hydraulic Fluid
• Hydrochloric Acid (18.5%)
• Hydrogen Peroxide (30%)
• Isopropyl Alcohol
• Mineral Oil
• Chlorine Bleach (5% Sodium Hypochlorite)
• Sodium Hydroxide (40%)
• Sulfuric Acid (50%)
• Xylene
• Gasoline
• Antifreeze
• Diesel Fuel.

View the full Chemical Compatibility Guide for the Original DrainProtector™.

A unique engineering process allows the DrainProtector™ to be heavy enough to seal, yet light enough to be portable and easy-to-use. When it’s time for use, the DrainProtector™ is even simpler to apply at a moment’s notice. To use the DrainProtector, follow three easy steps to ensure maximum effectiveness:

1. Make sure the DrainProtector™ Safety Seal is the correct size
   For best results, use a DrainProtector™ Safety Seal that’s 6″ larger than the outside of the drain.
   
   
2. Apply the DrainProtector™ Safety Seal
   Remove debris from the drain area you’re covering. Remove the plastic film from the DrainProtector™ and save it to replace it after use. Place the DrainProtector™ Safety Seal YELLOW SIDE UP over the drain, grate, or manhole you are sealing.
   
   
3. Wash the DrainProtector™ Safety Seal before storage
   Wash the safety seal in warm water with a non-abrasive detergent or petroleum solvent cleaner. Dry with a cloth and re-apply the plastic film. Roll the DrainProtector™ Safety Seal (ORANGE SIDE IN) around its original tube and place it back into the provided box.